Ebco Sliding Wardrobe Shutter Fittings SWF 1

Rs. 197.00

Specification

Specification

Finish Black

Pcs./set Set

*If you have any specific question related to the product, please contact us.
One set is for one sliding shutters.Set of two sliding fittings with four wheels, each are fitted on top rack. (Refer fig.1).Set of two sliding fittings with one wheel, each are fitted on bottom track. (Refer fig.2).Cavities for sliding fittings are made at the four extreme ends of shutter. (Refer fig.3).Center distance between two rails should be 40 mm min. (Ref. Fig.4) IMPORTANT: TO BE ORDERED WITH THE ALUMINIUM RAILS. CODE NO. SFFA1.

Specification
Finish	Black
Pcs./set	Set

Related Items

Rs. 310.00

Specification

Specification

Finish Anodized silver

Pcs./set 2.44m

*If you have any specific question related to the product, please contact us.
Use Ø35mm cutter to make cavities on the inside of shutter. (Refer Fig.1).Cavity should be 10mm deep.Fit top housing and bottom housing in top and bottom cavities respectively.Rail is fitted in a slot at top and bottom of cabinet. Groove should be 8mm wide and 6mm deep. (Refer Fig.2).Wheel of bottom housing should sit in bottom rail.Spring loaded guide in top housing is pulled down so as to engage in top rail there by retaining the shutter. (Refer Fig.3).

Specification
Finish	Anodized silver
Pcs./set	2.44m

Rs. 134.00

Specification

Specification

Finish Plastic (wh/br)

Pcs./set 3.66 m

*If you have any specific question related to the product, please contact us.
Use Ø35mm cutter to make cavities on the inside of shutter. (Refer Fig.1).Cavity should be 10mm deep.Fit top housing and bottom housing in top and bottom cavities respectively.Rail is fitted in a slot at top and bottom of cabinet. Groove should be 8mm wide and 6mm deep. (Refer Fig.2).Wheel of bottom housing should sit in bottom rail.Spring loaded guide in top housing is pulled down so as to engage in top rail there by retaining the shutter. (Refer Fig.3).

Specification
Finish	Plastic (wh/br)
Pcs./set	3.66 m

Rs. 94.00

Specification

Specification

Finish Nylon (WH/BR)

Pcs./set Set of 4 Pcs.

*If you have any specific question related to the product, please contact us.
Use Ø35mm cutter to make cavities on the inside of shutter. (Refer Fig.1).Cavity should be 10mm deep.Fit top housing and bottom housing in top and bottom cavities respectively.Rail is fitted in a slot at top and bottom of cabinet. Groove should be 8mm wide and 6mm deep. (Refer Fig.2).Wheel of bottom housing should sit in bottom rail.Spring loaded guide in top housing is pulled down so as to engage in top rail there by retaining the shutter. (Refer Fig.3).