*If you have any specific question related to the product, please contact us.
Use Ø35mm cutter to make cavities on the inside of shutter. (Refer Fig.1).Cavity should be 10mm deep.Fit top housing and bottom housing in top and bottom cavities respectively.Rail is fitted in a slot at top and bottom of cabinet. Groove should be 8mm wide and 6mm deep. (Refer Fig.2).Wheel of bottom housing should sit in bottom rail.Spring loaded guide in top housing is pulled down so as to engage in top rail there by retaining the shutter. (Refer Fig.3).
*If you have any specific question related to the product, please contact us.
One set is for one sliding shutters.Set of two sliding fittings with four wheels, each are fitted on top rack. (Refer fig.1).Set of two sliding fittings with one wheel, each are fitted on bottom track. (Refer fig.2).Cavities for sliding fittings are made at the four extreme ends of shutter. (Refer fig.3).Center distance between two rails should be 40 mm min. (Ref. Fig.4) IMPORTANT: TO BE ORDERED WITH THE ALUMINIUM RAILS. CODE NO. SFFA1.
*If you have any specific question related to the product, please contact us.
Drill 2 holes on each internal side of wardrobe.First hole should be 24mm from the top internal face of cabinet and center distance to be 32mm apart. (Refer fig. 1).Holes should be at equal height.
*If you have any specific question related to the product, please contact us.
Drill 2 holes on each internal side of wardrobe.First hole should be 24mm from the top internal face of cabinet and center distance to be 32mm apart. (Refer fig. 1).Holes should be at equal height.
*If you have any specific question related to the product, please contact us.
Drill 2 holes on each internal side of wardrobe.First hole should be 24mm from the top internal face of cabinet and center distance to be 32mm apart. (Refer fig. 1).Holes should be at equal height.
